-
1
In a nonreactive stockpot, combine the milk ?and the diluted lipase. Gently heat over low heat to 86u00b0 F. This should take 25 to 30 minutes. Remove from the heat.
-
2
Sprinkle the starter over the milk and let it rehydrate for 2 minutes. Whisk the starter into the milk, using an up-and-down motion to distribute thoroughly. Cover, maintaining a temperature of 86u00b0 F, and allow the milk to ripen for 1 hour.
-
3
Add the diluted calcium chloride: whisk it in gently, using an up-and-down motion, for a few minutes, then add the rennet in the same way.
-
4
Cover and allow to sit at 86u00b0 F for 1 hour. The curds will be a sold mass at this point and the light yellow whey will float to the top. The curds should show a clean break when test-cut with a knife; if there is no clean break at this point, let the curds set for another 10 minutes, then test again.
-
5
Cut the curds into 1/2-inch cubes. Maintaining a temperature of 86u00b0 F, allow to sit undisturbed for 10 minutes.
-
6
Using a flexible rubber spatula, gently stir the curds for 20 minutes, raising the temperature to 90u00b0 F. This action will release more whey and keep the curds from matting together. The curds will look more pillow-like in shape at the end of this process.
-
7
Let the curds rest for 5 minutes, undisturbed. They will settle to the bottom of the pot.
-
8
Line a strainer with dampened cheesecloth or butter muslin, leaving excess cloth hanging over the sides of the strainer. Using a slotted spoon, spoon the curds into the prepared strainer.
-
9
Tie the corners of the cloth together to create a draining sack, slip a wooden spoon handle through the knot, and hang over a deep cooking pot or bucket to drain for 10 minutes. Transfer the curds from the cheesecloth to a square feta cheese mold, press them into the corners, generously salt the surface, and allow to finish draining. After 1 hour, flip the cheese over, return to the mold, and generously salt the surface again. This will help even out the texture and firm the cheese. Cover the molds with cheesecloth and allow to drain at room temperature for 8 hours or overnight.
-
10
Cut the cheese into slices that are 1 1/4 inches thick, and then cut again into cubes. Sprinkle the chunks with salt, making sure all the surfaces are covered. Loosely cover the bowl with a lid or plastic wrap and allow to age in the salt for 5 days in the refrigerator. The cheese can be covered with brine at this point for 21 to 30 days to further cure and add saltiness. If the finished cheese is too salty for your taste, set the cheese in nonchlorinated water for 1 hour then drain before using.
-
11
**Specialized cheese making ingredients and supplies can be purchased online from The Beverage People, www.thebeveragepeople.com. Other resources can be found on www.artisancheesemakingathome.com
