-
1
Begin by getting a large pot on the stove. Add the ground beef and water, and bring to a boil. Once the water is boiling, reduce the heat to medium, and begin stirring the beef, breaking it up as you stir. Continue this process for about 45 minutes. Skim off any of the crud that might float to the top and discard it.
-
2
Next, add all of the remaining chili ingredients on the above list, giving a good stir. Bring this mixture to a boil, then reduce heat to a simmer, cover, and let it cook for approximately 3 1/2 hours, stirring from time to time. When done, remove bay leaves.
-
3
Now if you are living on the edge and like that fatty flavor, you could go ahead and serve this right now, but instead, I recommend that you take it off of the stove, let it cool, then place it in the refrigerator overnight. The reason you will probably want to do this is that when you remove the chili the next day, the fat that was cooked off from boiling the ground beef will rise to the top, allowing you to remove all of that fat. So do just that, and remove that thin layer of fat from the chili.
-
4
Once you have removed the fat, put it back onto the stove, bringing it up to a boil and heat throughout, then get ready to serve.
-
5
Remember now, I went four-way, which means, spaghetti, chili, onions, and cheese.
-
6
To serve, add a layer of the cooked spaghetti on the bottom of your bowl. Ladle a generous amount of the chili on top of the spaghetti. Top with onions, and a lot of grated cheese. Place a small handful of oyster crackers on the side, and dig in!
-
7
You will be surprised not only with the awesome texture of this chili, but more importantly, the flavor. You get the richness from the cocoa powder, and the clove and cinnamon really stand out. But it is also the texture you get from the onion and cheese that make this chili just melt in your mouth.
-
8
Give it a shot, and I hope you enjoy the recipe!
